Cavaliere UC200-1830S Use and Care Manual download pdf (Page 9)

Venting Methods

Page 7

IMPORTANT:

NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or •

garages. All exhaust must be ducted to the outside.

Use metal/aluminum duct work only. •

Fasten all connections with sheet metal screws and tape all joints with certied Silver Tape or Duct Tape.•

Use caulking to seal exterior wall or roof opening around the cap.•

Venting Methods:

Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow may be needed.•

This range hood is factory set for vertical venting using round or rectangular vent adapter but can be con-•

verted to horizontal venting by swapping the round vent adapter on top with rectangular vent adapter behind

the range hood as shown below:

Vertical roof venting

Roof cap

Option 2:

Side wall cap

Recirculate venting

Option 1:

Type 3:

6-inch round vent adapter on top

of the range hood.

Type 2:

3-1/4 x 10-inch rectangular vent

adapter on top of the range hood.

Type 1:

3-1/4 x 10-inch rectangular vent

adapter behind the range hood.

Option 3:

Horizontal wall venting

(available with 2000 Class only)

NOTE: The charcoal lters are preinstalled if you purchased the range hood with re-circulating kit from us.

Remove aluminum lters on hood.1.

Position the charcoal lter onto the motor and turn until it locks. Re-install aluminum lters.2.

Charcoal lters must be replaced after 120 hours of use (or approximately every 2 to 3 months based on the 3.

average of 1 to 2 hours of daily cooking time). Available at your local resellers.

Charcoal Filter Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Cavaliere UC200-1830S Use and Care Manual Page 9