Cavaliere AP238-PSL-36 Instruction Manual download pdf (Page 21)

Page 19

SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!

For optimal operation, clean range hood and all bafe/spacer/lter/grease tunnel/oil container regularly. Regular care will

help preserve the appearance of the range hood.

Cleaning Exterior surfaces:

Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent (e.g. Comet •

Power Scruv

, EZ-Off

oven cleaner), or steel wool/scoring pads, which will scratch and damage the stainless steel

surface. For heavier soil use liquid degrease such as “Forumla 409

” or “Fantastic

” brand cleaner.

If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the hood. Avoid getting •

cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: Do not

leave on too long as this may cause damage to hood nish. Use soft towel to wipe off the cleaning solution, gently

rub off any stubborn spots. Use dry soft towel to dry the hood.

After cleaning, you may use non abrasive stainless steel polish such as 3M•

or ZEP

, to polish and buff out the stainless

luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.

DO NOT allow deposits to accumulate or remain on the hood.•

DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause rusting.•

DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel •

for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse with water after ex-

posure and wipe dry with a clean cloth.

Cleaning Stainless Steel Bafe Filters:

IMPORTANT: Drain oil from oil containers before oil and residue overow!

The metal lters tted by the factory are intended to lter out residue and grease from cooking. It need not be replaced •

on a regular basis but are required to be kept clean.

Filters should be cleaned after every 30 hours of use.•

Remove and clean by hand or dishwasher. Spray “Formula 409•

” or equivalent degreasing detergent and leave to soak

if heavily soiled. Dry lters and re-install before using hood.

Replacing Filters:

The stainless steel bafe lters are designed to last but are required to be replaced if damaged, please contact your local •

reseller for replacement lters.

Replacing the light bulb:

This range hood uses halogen bulb (please refer to the actual specication of the hood purchased):•

USA/Canada:

35W Type MR16 12V / Type GU10 120V

Europe and other Countries:

35W Type MR16 12V / Type GU10 220V

Make sure the range hood is unplugged or turn OFF breaker. •

Make sure the lights are cool to touch, carefully align the ar-•

row on the inner ring with the arrow on the outer ring where it

says OPEN. The inner ring will loosen and the light bulb will

be available for removal. Install a new halogen light bulb and

reverse the steps.

Turn ON breaker and range hood to test for operation.•

WARNING

Hazard of Burns!

Light bulb become extremely hot when turned on.

DO NOT touch bulb until switched off and cooled.

Touching hot bulbs could cause serious burns.

Align arrows on both rings

Maintenance

1 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Cavaliere AP238-PSL-36 Instruction Manual Page 21

Comments to this Manuals

Related products and manuals for Cooker hoods Cavaliere AP238-PSL-36